The partial pressure of hydrogen sulfide in a gas, the mole fraction of H2S times the total absolute pressure: pH2S = y·P. It is the number NACE MR0175 / ISO 15156 classifies sour service by (0.05 psia, 0.3 kPa, is the sour limit) and the abscissa of its SSC severity figure (`PO.FA.Corrosion.H2S.Region`). The result is in the unit the pressure is given in: psia in, psia out.
A first-pass material for a line or tubing in CO2 service, chosen in the order NORSOK M-001 asks a designer to try them: carbon steel with a corrosion allowance if the bare rate over the design life fits the allowance; carbon steel with a corrosion inhibitor if the inhibited rate does; otherwise a corrosion-resistant alloy, the cheapest one that the temperature and the H2S allow. The function returns the material's name: "Carbon steel", "Carbon steel + inhibitor", "13Cr", "Duplex" or "Nickel alloy". It is the start of a materials selection, not its end: the selection report weighs cost, weldability, oxygen, chlorides and inspection too. For the CO2 corrosion blueprint's flowline, `=PO.CO.Mat.CO2Material(9.18, 1.38, 150, 1, 20, 3)` returns "13Cr".
Screens a live oil for asphaltene deposition by the de Boer plot: its undersaturation, the reservoir pressure less the bubble point, against its density at reservoir conditions. Light, highly undersaturated oils hold the least asphaltene in solution and lose the most solvency as the pressure falls to the bubble point, so they sit in the severe region; heavy oils close to saturation sit in the no-problem region whatever their asphaltene content. The function returns the region, 0 for no problems, 1 for slight (possible) problems and 2 for severe problems, or either boundary's undersaturation at the given density, so a sheet can draw the plot.
This website uses cookies to enhance your experience and analyze site usage.
By clicking "Accept", you consent to the use of cookies for analytics purposes.
Read our privacy policy