Waterflood Performance LAMBDAs
Layered-reservoir waterflood predictions by Dykstra-Parsons and Stiles, and injector surveillance by the Hall plot and the voidage replacement ratio.
4 lambdas
PO.RES.Waterflood.DykstraParsons(k, Mob, Mode)
The Dykstra-Parsons method for a waterflood in a layered reservoir with no crossflow between the layers. It returns the permeability variation V of the layer permeabilities, or, at the moment each layer breaks through, the vertical coverage and the water-oil ratio. Plotted against each other, coverage and WOR show how much of the section has been flooded by the time the producer reaches a given WOR. The layers are sorted by permeability inside the function, so they can be entered in any order. Each layer is a piston-like displacement with the same pressure drop across it, and the layers are of equal thickness, as in the original method.
PO.RES.Waterflood.Stiles(k, h, A_wo, Mode)
Stiles' method for a waterflood in a layered reservoir. The layers flood in order of permeability, the most permeable first, and the front in every layer advances in proportion to its permeability. At the moment each layer breaks through, the function returns either the fraction of the floodable volume swept so far or the surface water cut. Plotted against each other they give the water cut against recovery. Unlike Dykstra-Parsons, Stiles takes layers of any thickness and treats the mobility ratio as one; the oil and water mobilities enter only the water cut, through the ratio A.
PO.RES.Waterflood.Hall(dt, Pwf, Pe, Q, Mode)
The Hall plot of a water injector: the Hall integral Σ (pwf − pe) Δt against cumulative injection Σ q Δt, and the slope of the line through them. Under steady radial flow the slope is 141.2 μ (ln(re/rw) + s)/(k h), so a constant slope means constant injectivity, a slope that bends up means plugging or a growing skin, and one that bends down means a fracture opening or a negative skin. The data are per period, as a monthly injection report gives them: the days of injection in the period, the average bottomhole pressure and the average rate.
PO.RES.Waterflood.VRR(Np, Wp, Gp, Bo, Bw, Bg, Rs, Wi, Gi, Mode)
The voidage replacement ratio of a waterflood or a pattern: the reservoir volume injected over the reservoir volume withdrawn, per period or cumulative. A VRR of 1 holds the reservoir pressure; above 1 the pressure rises, below 1 it falls. Withdrawal counts the oil, the free gas (produced gas less the gas that was in solution in the produced oil) and the water, each at reservoir conditions. Injection counts the water and any gas injected.