Plunger Lift LAMBDAs
Foss and Gaul's casing pressure and gas requirement for a conventional plunger, and the cycle time, cycles per day and liquid rate.
2 lambdas
PO.PE.Plunger.Feasibility(depth, tubing_id, tubing_od, casing_id, plunger_wt, pt, slug, k, plhf, glr, pc, output)
Can a conventional plunger lift this well? Foss and Gaul (1965) worked out the casing pressure a plunger needs to bring a liquid slug to surface: enough to push the plunger's weight, the slug's head and friction and the tubing pressure, plus the friction of the gas below the plunger, which grows with depth. The function returns that minimum casing pressure at the end of the rise, the maximum the casing must reach before the plunger leaves bottom (the gas then expands from the annulus into the tubing), and the rule-of-thumb gas the well must make, 400 scf per barrel of liquid for every 1,000 ft of lift. "Go" is 1 when the well's gas-liquid ratio and the casing pressure it builds up to meet both, 0 when either falls short.
PO.PE.Plunger.Cycle(depth, liquid_ht, v_gas, v_liq, v_rise, buildup, afterflow, slug, output)
How many trips a plunger can make in a day, and the liquid it lifts. A cycle is the shut-in, the rise and the afterflow. During the shut-in the plunger falls, first through the gas in the tubing and then, more slowly, through the liquid standing above the bottom stop, while the casing builds pressure; the well can only be opened when both are done, so the shut-in is the longer of the fall and the buildup. The plunger then rises at its rise velocity and the well flows on (the afterflow) until it is shut in again. The function returns the fall and rise times, the cycle, the cycles per day and the liquid rate, the slug times the cycles.