PO.PTA.Bilinear.Fit(t, dp, q, B, mu, h, phi, ct, k, output)

The bilinear-flow specialized plot of a well with a finite-conductivity vertical fracture: the least-squares line through the pressure drop against the fourth root of time over the points you pass, and the fracture conductivity kf·w its slope gives. In bilinear flow the fluid moves linearly along the fracture and linearly from the formation into it at the same time. The log-log derivative then has a slope of ¼, and Δp plots as a straight line through the origin against Δt^¼. Pass only the points inside that quarter-slope window, for example with `FILTER`. The intercept should be close to zero; a large one points to fracture-face or choked-fracture skin, or to points outside the window.

PO.PTA.Linear.SqrtT(t, dp, q, B, mu, h, phi, ct, k, output)

The linear-flow specialized plot of a well with a high-conductivity vertical fracture (or of a well in a channel): the least-squares line through the pressure drop against the square root of time over the points you pass, and the product xf·√k its slope gives. In formation linear flow the fluid moves straight toward the fracture faces. The log-log derivative then has a slope of ½, and Δp plots as a straight line against √Δt. With k known from radial flow, the function also returns the fracture half-length. Pass only the points inside the half-slope window, for example with `FILTER`. A positive intercept is the fracture-face skin; a negative one usually means some points come from the end of the window.

PO.PTA.StepRate.Fit(q, p, nlow, output)

The two-line fit of a step-rate injection test: the stabilized bottomhole pressure at the end of each rate step plotted against the rate falls on two straight lines, a steep one while the rock takes water through the matrix and a flatter one once a fracture is open. Their intersection is the fracture extension pressure and the rate at which the fracture opens. The function fits both lines by least squares. You either give the number of steps on the lower (matrix) line, or pass 0 to let it try every split and keep the one with the smallest total squared error. It returns the extension pressure and rate, the two slopes and the split it used.

PO.PTA.Pulse.Analysis(tL, dp, dtC, Fp, n, q, B, mu, h, robs, output)

The Kamal-Brigham analysis of a pulse test, without reading their charts. The active well alternates between flowing and shut in. An observation well a distance r away sees a small oscillating pressure on top of the trend. For one pulse you read two things off that response: the time lag tL, from the end of the pulse to the extremum it causes, and the amplitude Δp, the extremum's vertical distance from the line tangent to the curve at the two neighbouring extrema of the opposite kind. The function computes the line-source response of the whole pulse train inside the formula. It finds the diffusivity whose response has the measured lag, reads the dimensionless amplitude off that response, and returns the interwell permeability and the porosity-compressibility product φ·ct. It can also return the two chart ordinates Kamal and Brigham plot, (tL)D/rD² and ΔpD·(tL/ΔtC)², for checking against the charts.

Need a custom LAMBDA? Request a Lambda