Pore Pressure and Geomechanics LAMBDAs
The overburden, pore pressure and fracture gradient that bound the mud-weight window, and the stresses, elastic moduli and rock strength of a 1D mechanical earth model.
8 lambdas
PO.GM.Density.Gardner(Vp, A, B)
Bulk density from P-wave velocity by Gardner's power law, the usual stand-in for a density log over a section logged only with sonic. Fill a density column with it, then pass the column to `PO.GM.Stress.Overburden`. Returns the bulk density in g/cc.
PO.GM.Stress.Overburden(Z_ft, TVD_ft, Rho_gcc, Sv0_psi)
Overburden (vertical) stress at a depth, by integrating a bulk-density log down from its first depth, the Sv every pore-pressure and fracture-gradient method starts from. Returns three cells: Sv in psi, the overburden gradient Sv/Z in psi/ft, and the same gradient as an equivalent mud weight in ppg.
PO.DE.PP.Eaton(Sv, Pn, Observed, Normal, Mode)
Pore pressure in shale by Eaton's method, from how far a sonic or resistivity log departs from its normal-compaction trend at the same depth. Undercompacted, overpressured shale is slower (higher transit time) and more conductive (lower resistivity) than the trend. Returns the pore pressure in the unit Sv and Pn are given in: psi, psi/ft or ppg.
PO.DE.FG.Eaton(Sv, Pp, Nu)
Fracture pressure or gradient by Eaton's method: the pore pressure plus the share of the effective overburden that Poisson's ratio transmits to the horizontal. It is the upper bound of the mud-weight window. Returns the fracture pressure in the unit Sv and Pp are given in: psi, psi/ft or ppg.
PO.DE.FG.MatthewsKelly(Sv, Pp, Ki)
Fracture pressure or gradient by Matthews and Kelly: the pore pressure plus a matrix-stress coefficient times the effective overburden (the matrix stress). The coefficient comes from their empirical chart, or from leak-off tests in the area. Returns the fracture pressure in the unit Sv and Pp are given in: psi, psi/ft or ppg.
PO.GM.Stress.MinHorizontal(Sv, Pp, Nu, Alpha, E, EpsMin, EpsMax)
The minimum and maximum horizontal stresses by the uniaxial-strain (poroelastic) model, with tectonic strain terms: the stresses of a 1D mechanical earth model, the fracture closure stress and the frac-barrier contrast between layers. Returns two cells, in the unit of Sv, Pp and E (psi): Shmin, then SHmax.
PO.GM.Elastic.Dynamic(Vp_fts, Vs_fts, Rho_gcc)
Dynamic Young's modulus, Poisson's ratio, shear modulus and bulk modulus from the compressional and shear velocities of a dipole sonic log and the bulk density, the first step of a log-based mechanical earth model. Returns four cells: E in psi, Poisson's ratio, G in psi and K in psi.
PO.GM.Strength.UCS(DT_usft, Mode)
Unconfined compressive strength (UCS) of a rock from its compressional sonic transit time, by a named empirical correlation: McNally's for sandstone or Horsrud's for shale. UCS is the strength input of wellbore-stability and sanding checks. Returns two cells: UCS in MPa (the unit the correlations are fitted in), then in psi.