Permeability of a sandstone at irreducible water saturation from porosity and Swirr, by Timur's empirical fit to core data. Use it where a log or NMR Swirr is known and the zone is at irreducible saturation, above the transition zone. Returns k in mD.
Formation resistivity factor from Archie's equation. It is the ratio of the resistivity of a rock fully saturated with water to the resistivity of that water, expressed through porosity. F = a / φ^m. Porosity is a fraction. a and m come from a log-log plot of F against porosity, or from a named pair such as Humble.
Water saturation in a clean formation from the general Archie equation. Porosity, water resistivity and true resistivity fix the bulk volume of water once the tortuosity factor, cementation exponent and saturation exponent are chosen. Sw = ((a / φ^m) * (Rw / Rt))^(1/n). Porosity is a fraction, resistivities are ohm·m, and a, m and n are dimensionless. With Vsh = 0 the shaly-sand equations in this batch reduce toward this one, at the a and m those equations bake in.
Sandstone permeability from the formation factor, the correlation Carothers published in 1968. It is a statistical fit, not a pore-scale derivation, and it applies to sandstones. The limestone fit is a different equation and is not this one. k = 7×10^8 / F^4.5, with k in millidarcies and F dimensionless.
Shale volume from the gamma-ray index by Clavier's nonlinear curve. Like the Larionov transforms it reads less shale than the linear index in the middle of the range, and it meets the index at both ends. Returns Vsh as a fraction.
Permeability from porosity and irreducible water saturation by the Coates free-fluid form, in which the ratio of free to bound fluid, (1 − Swirr)/Swirr, carries the pore-size effect. It is the same idea as the NMR Coates model, written with a log Swirr in place of the NMR bound-fluid volume. Returns k in mD.
Porosity from the density log in a clean formation. The bulk density sits between the matrix density and the fluid density, and the fraction of the way across is the porosity. φ = (ρma − ρb) / (ρma − ρf). All three densities share one unit, g/cm³ on a density log. Shale and gas corrections are not in this equation.
This website uses cookies to enhance your experience and analyze site usage.
By clicking "Accept", you consent to the use of cookies for analytics purposes.
Read our privacy policy