The conductivity kf·wp of a propped fracture, from the mass of proppant placed, not from the hydraulic width the fracture had while it was pumped. After closure the fracture is as wide as its proppant pack: the pack's bulk volume, mass/((1 − φp)·ρp), spread over the two wings' area 2·xf·hf. The hydraulic width at the end of pumping is several times larger, so a dimensionless conductivity CfD = kf·w/(k·xf) worked from it overstates the fracture. Divide the result by kf for the propped width in ft, or pass it to `PO.FRAC.Well.Cfd` as kf with a width of 1.
The fracturing-fluid efficiency of an injection, from the G-function value at which the fracture closed on its falloff. Efficiency is the share of the injected volume still in the fracture at shut-in; the rest has leaked off. Nolte's material balance ties it to the time the fracture takes to close: a fracture that closes quickly (small Gc) lost most of its fluid while it was pumped. The leakoff exponent α is a required mode, the same one used for the G-function (`PO.FRAC.DFIT.GFunction`). With α = 0.5 the result is Barree's η = Gc/(2 + Gc).
Nolte's G-function of a fracture falloff, the time axis of the G-function plot that a diagnostic fracture injection test (DFIT) is read on. You pass the shut-in times, the pumping time and the falloff pressures. The function returns, as a column, the dimensionless shut-in time ΔtD, Nolte's g(ΔtD), G(ΔtD), the pressure derivative dP/dG, or the superposition derivative G·dP/dG. While the fracture is open and leakoff is normal, the pressure falls on a straight line against G and G·dP/dG on a straight line through the origin. Closure is where G·dP/dG leaves that line. Pressure-dependent leakoff, height recession and tip extension each bend it in their own way. The leakoff exponent α is a required mode: 1 for a fracture whose area grows linearly with time (low leakoff, high efficiency, the usual choice) and 0.5 for one whose area grows with √t (high leakoff, low efficiency).
This website uses cookies to enhance your experience and analyze site usage.
By clicking "Accept", you consent to the use of cookies for analytics purposes.
Read our privacy policy