PO.FRAC.Design.UFD

The optimum fracture for a given mass of proppant, by unified fracture design (UFD). The proppant mass that reaches the pay sets the proppant number Np = 2·kf·Vprop/(k·Vres), and the proppant number alone fixes the dimensionless fracture conductivity CfD that gives the largest pseudo-steady-state productivity index JD. The function returns the proppant number, the optimum CfD, that largest JD, and the half-length and propped width that realise it. A design whose CfD is far from the optimum is either a bottleneck (CfD well below it: too long and narrow) or too short and wide (well above it).

PO.FRAC.Design.Conductivity

The conductivity kf·wp of a propped fracture, from the mass of proppant placed, not from the hydraulic width the fracture had while it was pumped. After closure the fracture is as wide as its proppant pack: the pack's bulk volume, mass/((1 − φp)·ρp), spread over the two wings' area 2·xf·hf. The hydraulic width at the end of pumping is several times larger, so a dimensionless conductivity CfD = kf·w/(k·xf) worked from it overstates the fracture. Divide the result by kf for the propped width in ft, or pass it to `PO.FRAC.Well.Cfd` as kf with a width of 1.

PO.FRAC.Design.PadFraction

The share of the slurry volume to pump as pad, clean fluid ahead of the proppant, from the fluid efficiency of the treatment: ε = (1 − η)/(1 + η) (Nolte, 1986). The same number is the exponent of Nolte's proppant ramp, c(t) = ce·[(t − tpad)/(te − tpad)]^ε, which leaves the whole created length propped at a uniform concentration at the end of pumping. A low efficiency, from high leakoff, needs a large pad.

PO.FRAC.Eval.ISIP

The instantaneous shut-in pressure (ISIP) at the fracture, and the net pressure and fracture gradient it gives, from the ISIP read at surface when the pumps stop. At shut-in the pipe friction and the perforation friction vanish, so the bottomhole ISIP is the surface ISIP plus the static column of the treating fluid. The net pressure is the bottomhole ISIP less the closure stress: the pressure that held the fracture open at the end of pumping, which the geometry models predict and which the net-pressure plot (Nolte-Smith) follows during the job.

Need a custom LAMBDA? Request a Lambda